Thymosin beta-4 is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Last reviewed on 2026-03-11. Where a claim depends on a specific study, the study is described rather than over-claimed.
TB-500 is a synthetic heptapeptide with the sequence Ac-LKKTETQ. It corresponds to a short N-terminal region of thymosin beta-4, a 43-amino-acid protein found in many cell types. The fragment contains an actin-binding motif, which is one reason it appears in laboratory studies of cell migration and cytoskeletal dynamics. TB-500 is not the full-length protein and is produced as a research chemical rather than an approved therapeutic agent. Its molecular weight is approximately 889 Da.
Several names appear in scientific and commercial contexts for this peptide. The label TB-500 is informal and does not follow standard biochemical nomenclature. Research articles more often describe the compound as a thymosin beta-4 fragment, Tβ4 fragment, or by its sequence Ac-LKKTETQ. Confusing TB-500 with full-length thymosin beta-4 can lead to incorrect assumptions about activity because the fragment lacks the remaining residues of the parent protein. The relationship between fragment and parent protein remains an active area of study.
Regulatory status differs by country, but TB-500 is not an approved pharmaceutical in major jurisdictions. It is commonly sold as a research chemical for laboratory use, which places responsibility for identity and purity on the supplier and the laboratory. Published human data are limited, and most reports involve preclinical models or cell culture. Questions about whether the fragment mimics all actions of thymosin beta-4, and under which conditions, remain open. Independent verification of any material is therefore a practical requirement in research settings.
TB-500 is a synthetic peptide preparation marketed under a name derived from thymosin beta-4, a 43-residue actin-binding protein first isolated from thymus tissue. The full-length protein has a reported molecular mass near 4963 Da, while material sold as TB-500 is often described as a fragment containing the actin-binding motif LKKTETQ. Because suppliers use the name inconsistently, published sources sometimes refer to the same label as a fragment, a synthetic copy, or a related analog. This naming ambiguity complicates direct comparison of reports across studies.
Laboratory work on thymosin beta-4 describes binding to monomeric actin and effects on cell migration, angiogenesis, and inflammatory signaling in cultured cells. Animal models have examined skin, corneal, and cardiac repair after injury, with outcomes reported mainly in preclinical literature. Most of that evidence concerns the parent protein rather than preparations labelled TB-500, so extrapolation from animal findings to a specific commercial product remains uncertain. Whether the two behave identically in living systems has not been established in controlled human studies.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C38H68N10O14 | Calculated for the acetylated heptapeptide |
| Molecular weight | ~889 Da | Monoisotopic mass approximately 889.0 Da |
| Amino acid sequence | Ac-LKKTETQ | N-terminal acetylated seven-residue peptide |
| Appearance | White to off-white powder | Typically supplied as a lyophilized solid |
| Solubility class | Water-soluble | Peptides of this size generally dissolve in aqueous media |
Research peptides are typically supplied as a white to off-white lyophilised powder in a sealed vial. The dry solid is more stable than a solution and is normally kept refrigerated or frozen until use. Dissolution is usually done in water, phosphate-buffered saline or a similar aqueous medium, depending on the assay. Because the material is hygroscopic and easily contaminated, opening vials in a low-humidity environment and recording the lot number before use are standard laboratory practices.
Once in solution, short peptides are generally less stable than the dry powder, and repeated freeze-thaw cycles are a common cause of loss. Laboratory guidance usually calls for aliquoting on first dissolution and storing aliquots at -20 °C or below, away from light. Adsorption to plastic and glass surfaces can lower measured concentration, particularly at low concentrations, so container material and buffer choice can affect results. Visible cloudiness, colour change or unexpected precipitate is a signal to re-check the material.
Dry powder is commonly held at minus twenty degrees Celsius, with some suppliers recommending lower temperatures for long-term archival storage. Once dissolved, solutions are typically kept cold and protected from light, since aqueous peptide solutions can lose integrity through hydrolysis or oxidation over time. Stability data specific to this fragment are limited in the public literature, and much of the guidance comes from general peptide handling practice rather than from controlled degradation studies. Users therefore treat stated shelf lives as approximate rather than fixed.
Identity and purity are normally assessed with reversed-phase high-performance liquid chromatography, paired with mass spectrometry to confirm molecular mass. A certificate of analysis reports a purity percentage, usually derived from chromatographic peak area, but that figure does not by itself prove a correct sequence or the absence of counterions. Independent verification may include amino acid analysis or peptide mapping. Batch-to-batch variation is a documented concern in the research chemical market, and the gap between a quoted purity value and actual peptide content can be substantial when the material is a salt or retains residual water.
Material is normally supplied as a lyophilised powder in a sealed vial. The powder is hygroscopic, so exposure to humid air leads to water uptake, caking and gradual loss of the fluffy texture that indicates a good freeze-dry. Vials are best kept sealed with desiccant, protected from light and stored cold. Letting a cold vial warm to room temperature before opening reduces condensation on the contents. Purity is normally reported from a chromatographic run, and that figure applies to the batch as tested rather than to the vial after repeated opening.
Once dissolved, the peptide is far less stable than the dry powder. Aqueous solutions are subject to hydrolysis, oxidation at susceptible residues and gradual loss of material through adsorption onto glass and plastic surfaces. Terminal glutamine can cyclise under some conditions, producing a related species that complicates purity assessment. Dilute solutions tend to lose a larger fraction of material to surfaces than concentrated ones. Buffers, pH and ionic strength all influence the rate of change, so stability figures are only meaningful when those parameters are stated alongside the storage interval.
Detection in biological samples relies on mass spectrometry, typically liquid chromatography coupled to tandem mass spectrometry after peptide extraction and enrichment. Intact peptides can also be confirmed by high-resolution mass measurement together with fragmentation data. Detection windows in urine are short because the peptide is degraded by proteases and cleared quickly, and concentrations are low. Many jurisdictions treat the compound as a prohibited substance in sport, grouped with peptide hormones and related factors, while it is not an approved therapeutic product. Identity and purity statements therefore rest on certificates of analysis, ideally issued by an independent laboratory.
=== Natural occurrence === Hawthorn flowers have a heavy, complicated scent, the distinctive part of which is triethylamine, which is also one of the first chemicals produced by a dead human body when it begins to decay. Due to the scent, it is considered unlucky in British culture to bring hawthorn into a house. Gangrene and semen are also said to possess a similar odour.
=== Biosynthesis and catabolism === The precursor to asparagine is oxaloacetate, which a transaminase enzyme converts to aspartate. The enzyme transfers the amino group from glutamate to oxaloacetate producing α-ketoglutarate and aspartate. The enzyme asparagine synthetase produces asparagine, AMP, glutamate, and pyrophosphate from aspartate, glutamine, and ATP. Asparagine synthetase uses ATP to activate aspartate, forming β-aspartyl-AMP. Glutamine donates an ammonium group, which reacts with β-aspartyl-AMP to form asparagine and free AMP.
=== P53 and p73 === p53 and p73 are tumor suppressor proteins and their degradation is tightly regulated by ubiquitination. Recently it was shown that their degradation can also occur via an ubiquitin-independent process; NQO1 blocks p53 and p73 degradation in the presence of NADH and protects them from 20S proteasomal degradation. This protein-protein interaction between p53 and NQO1 was non-catalytic.
Sources: en.wikipedia.org
As part of a major effort to address the ongoing economic crisis of the US, legislation was introduced to "reconstitute Project Socrates". The updated version of Socrates supports incubators by enabling users with technology-based facts about the marketplace, competitor maneuvers, potential partners, and technology paths to achieve competitive advantage. Michael Sekora, the original creator and director of Socrates says that a key purpose of Socrates is to assist government economic planners in addressing the economic and socioeconomic issues (see above) with unprecedented speed, efficiency and agility. Many for-profit or "private" incubation programs were launched in the late 1990s by investors and other for-profit operators seeking to hatch businesses quickly and bring in big payoffs. At the time, NBIA estimated that nearly 30% of all incubation programs were for-profit ventures. In the wake of the dot-com bust, however, many of those programs closed. In NBIA's 2002 State of the Business Incubation survey, only 16% of responding incubators were for-profit programs. By the 2006 SOI, just 6% of respondents were for-profit. Although some incubation programs (regardless of nonprofit or for-profit status) take equity in client companies, most do not. Only 25% of incubation programs report that they take equity in some or all of their clients.
=== Short-term === The high short-term radioactivity of spent nuclear fuel is primarily from fission products with short half-life. The radioactivity in the fission product mixture is mostly due to short-lived isotopes such as 131I and 140Ba, after about four months 141Ce, 95Zr/95Nb and 89Sr constitute the largest contributors, while after about two or three years the largest share is taken by 144Ce/144Pr, 106Ru/106Rh and 147Pm. Note that in the case of a release of radioactivity from a power reactor or used fuel, only some elements are released. As a result, the isotopic signature of the radioactivity is very different from an open air nuclear detonation where all the fission products are dispersed.
=== Synthesis === The sizeable number of serotonergic drugs for treating migraines all incorporate the indole nucleus found in serotonin itself. It is thus of interest that a compound based on a benzopyran manifests much the same activity.
Sources: en.wikipedia.org
TB-500 is a synthetic heptapeptide corresponding to a fragment of thymosin beta-4. It is used in laboratory research and is not an approved drug.
No. Thymosin beta-4 is a 43-amino-acid protein, while TB-500 represents only a short N-terminal segment. The two should not be treated as interchangeable in experimental design.
It is often called a thymosin beta-4 fragment, Tβ4 fragment, or Ac-LKKTETQ. The name TB-500 is mainly a commercial or catalog label rather than a formal chemical name.
Not necessarily. TB-500 is a commercial label that suppliers apply to synthetic peptides described as thymosin beta-4 or a fragment of it. Published research most often studies the full-length protein, so statements about one do not automatically transfer to the other.